ELECTRIC SERVO NUTRUNNER AFC1500 MULTI SYSTEM MULTI-2 UNIT HARDWARE MANUAL SECOND Edition March 2009 51327 Quadrate D
Never operate the equipment with wet handsFailure to observe this instruction may cause electric shock.Keep fingers away from the is turned ON or for
xi Table of Contents Chapter 1: Outline 1.1 About this Manual...
xii Table of Contents Chapter 5: Control Interfaces 5.1 Interface Board ……...…….………………………………………………….. 5-2 5.2 Interface Board DIP S
xiii Table of Contents 5.11 Ethernet-I/P Interface…...………………………………………………….. 5-55 5.11.1 Component Descriptions...………………………………………
xiv Blank Page
ii WARNING All applicable national and local codes must be followed when installing and operating the equipment detailed in this manual. FAILURE TO A
iii Revision Revision Date Revision History 1 04/2008 Initial Release 2 3/2009 Revision affecting most chapters including minor fixes, revis
iv Thank you for purchasing our Electric Servo Nutrunner - AFC1500 System. This instruction manual describes the procedures for installation, wiring
v Warranty Period FEC Inc. warrants that the equipment manufactured by it and delivered hereunder will be free of defects in material
Read all instructions before operating the Prior to use, read this instruction manual carefully precautions and instructions. Safety precautions in th
Never touch rotating devices or any part of the nutrunnerMake sure that no part of your body gets near any moving part of the tool. The spindle may r
Transport the equipment properly according to its weight. Failure to observe this instruction may causeThe conditions when transporting the equipment
Install all tools firmly where they can bear the maximum torque Failure to observe this instruction may causeInstall the AXIS Unit firmly Failure to o
Comments to this Manuals